Introduction of the adhesion technique of the glass protective film

- Oct 22, 2018 -

Glass protective film is a new type of energy-saving building material, which is one of the more popular glass decorations. The glass film not only can maintain the effect of heat preservation and UV protection, but also protects the privacy well, so it is deeply loved by consumers. Of course, there is also a set of specifications for the paste glass protective film.

 

The first is to cut the glass protective film, its length is about one centimeter longer than the length of the glass, so as to effectively avoid sticking or causing repeated stickers. The glass is cleaned before the glass protective film is applied, and then the cleaned glass is sprayed with some water to reduce the viscosity of the glass film so that its viscosity is not affected after drying.

 

  Secondly, after removing the release film, sprinkle some water on the back side of the glass film, which can facilitate the construction of the back, so that the film can be moved during the process of laying and finding a suitable position. Measure the size on the glass, align the upper end of the glass, and paste it from top to bottom. If it is not aligned at one time, you can peel it off again and then spread it. This is the benefit of the watering mentioned above. Finally, the air bubbles in the glass protective film are scraped off with a squeegee. If the air bubbles are not punctured, the air bubbles are smeared and smeared, so that it is completely adhered to the glass. After the paving is completed, the excess portion can be cut off with a blade.http://www.pe-protectionfilm.com/